- How long does it take for P trap to dry?
- Does the vent go before or after the P trap?
- Does every P trap need a vent?
- How does a cheater vent work?
- How close does a vent need to be to a shower drain?
- Why is s trap illegal?
- How far below drain should P trap be?
- Does trap have to be directly below drain?
- Is it OK to have 2 P traps?
- Which is better P trap or S trap?
How long does it take for P trap to dry?
three to five monthsIn the Pacific Northwest, where we’re located, it takes three to five months of not using a fixture before the water in the P-trap dries out enough to let sewer gases inside..
Does the vent go before or after the P trap?
Plain and simple, the vent comes AFTER the trap. A vent before the trap does absolutely nothing. The open drain inlet at the bottom of the sink is the vent before the trap. It is why fixtures do not need ANY vent to drain, they need a proper drain to not siphon the trap.
Does every P trap need a vent?
Every fixture is required to have an internal or external trap; double trapping is prohibited by plumbing codes due to its susceptibility to clogging. Every plumbing fixture must also have an attached vent. The top of stacks must be vented too, via a stack vent, which is sometimes called a stink pipe.
How does a cheater vent work?
A cheater vent (or air admittance valve) is a vent that comes off the fixture — for example, a sink in a new powder room — and is buried in the wall. … AAVs are designed to not allow sewer gas out into your wall cavity. It’s a mechanical vent that allows necessary air into the system to help drains operate efficiently.
How close does a vent need to be to a shower drain?
904.6 Extension through the wall. Vent terminals extending through the wall shall terminate a minimum of 10 feet (3048 mm) from the lot line and 10 feet (3048 mm) above average ground level.
Why is s trap illegal?
Back to “S” traps – The reason “S” traps aren’t allowed is because they have the potential to suck, or ‘siphon’, water out of the trap as the water flows down the drain. … Believe it or not, enough water to break the water seal at the trap and let sewer gases come in to the house.
How far below drain should P trap be?
24 inchesAccording to the International Residential Code, the maximum vertical distance between the sink drain and the entrance to the p-trap is 24 inches.
Does trap have to be directly below drain?
It doesn’t have to be directly under the shower drain, but it should be as close as possible. Shower drains and traps are notorious for getting hair clogs, and it’s best if they are reachable with a drain snake or cleaning tool of some sort.
Is it OK to have 2 P traps?
It is perfectly fine to have (2) “P” traps , one on eash sink of a (2) sink setup. As long as the “P” traps are not Double Trapped ( more than one trap serving a fixture ) then it is fine as long as the weir is sized correctly.
Which is better P trap or S trap?
A “P” trap drain will form a “P” shape to maintain a water seal, and the pipe will either go through the wall behind the fixture or extend several inches away from the sink drain before exiting through the floor. … With an “S” trap drain, the trap is easily siphoned dry with each use and the water seal no longer exists.